SSI features a vast line of professional underground and underwater locator products for every need including surveying, construction, ordnance removal, excavation and exploration. Our customers from the petroleum, water, sewer, power, telecom, cable and gas industries rely on SSI's reliability and dependability to make crucial measurements in the world's most challenging conditions. SSI's products are proudly made in the U.S.A. and offer an industry-leading warranty.
Magnetic Locators
ML-1 - All-inclusive magnetic locator with simple, one-handed operation.
The ML-1 is one of SSI's longest-enduring and popular products for magnetic detection. Whether you're seeking corner markers (iron or steel), well casings, steel drums or septic tank handles, this is the go-to magnetic locator for you. And for good reason. The ML series offers simple one-handed operation with an easy-to-learn keypad featuring only three buttons - no menus or cumbersome instructions to follow. The audio unit has the volume built into the on/off key; just hold down the key while it cycles through the settings. The ML-1 features strong monotube construction, providing structural integrity you can count on.
​
Key Features
-
Easy and simple one-hand operation; built-in handle
-
Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
-
Volume built into the on/off key; just hold down the key while it cycles through the settings
-
The electronic keypad "clicks" when a key is depressed. A "real" speaker is in the front panel, providing outstanding volume.
-
Microprocessor remembers the volume and gain settings from the last time the unit was on Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
-
Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼" tapered to 2 ½"-wide X 4 ½" tapered to 2 ½"-deep) provide the best structural integrity in a hand-held locator.
-
Lightweight; only about two pounds including batteries
-
Uses 2 regular alkaline 9-volt batteries, parallel; the unit is shipped with two spare batteries
-
Soft pack carrying case included (optional hard case available) Battery compartment separated from electronic components and the circuit board. No exposing electronics to replace the batteries.
ML-1M - All-inclusive magnetic locator with simple, one-handed operation plus digital metrics.
The ML-1M is one of SSI's longest-enduring and industry-leading products for magnetic detection. Whether you're seeking corner markers (iron or steel), well casings, steel drums or septic tank handles, this is the go-to magnetic locator for you. And for good reason. The ML series offers simple one-handed operation with an easy-to-learn keypad featuring only three buttons - no menus or cumbersome instructions to follow. The audio unit has the volume built into the on/off key; just hold down the key while it cycles through the settings. The ML-1M features strong monotube construction, providing structural integrity you can count on.
​
In addition to the features of the original ML-1, the ML-1M is metered, offering you added features without added complexity. The digital meter provides for visual signal strength, polarity indication, gain setting plus battery life display. These versions are engineered to operate identically with the same controls.
​
Key Features
-
Easy and simple one-hand operation; built-in handle
-
Easy to learn; 3 keypad switches: on/off and volume, sensitivity up and sensitivity down
-
Volume built into the on/off key; just hold down the key while it cycles through the settings
-
Electronic keypad with tactile switches. A real speaker is in the front panel, providing outstanding volume.
-
Microprocessor remembers the volume and gain settings from the last time the unit was on
-
Non-metered (ML-1) and metered (ML-1M) versions are designed to look, feel and operate the same
-
Over 5,000 ML-1M units in Afghanistan used for detection of improved explosive devices (IEDs) and unexploded ordnance (UXOs)
-
ML-1M version with LCD shows positive or negative polarity and signal strength. Detect edges of covers, pipe joints.
-
ML-1M adds features without complexity. No learning curve between units.
-
Strong aluminum monotube construction from the tip through the end of the handle and ABS injection-molded electronics case (3 ¼" tapered to 2 ½"-wide X 4 ½" tapered to 2 ½"-deep) provide the best structural integrity in a hand-held locator
-
Lightweight; only about two pounds including batteries
-
Uses 2 regular alkaline 9-volt batteries, parallel; included
-
Soft pack carrying case included (optional hard case available)
-
Battery compartment separated from electronic components and circuit board. No exposing electronics to replace the batteries.
-
Made in the USA - Built and serviced entirely in Wisconsin
ML-3S (40") - Short magnetic locator offers durable one-handed operation that's 100% waterproof.
The ML-3 is a much-anticipated and welcome addition to the ML family of magnetic locators from SSI. ML-3 magnetic locators represent the best in innovation at work for the water/sewer industry, surveying industry and military.
​
That's because the ML-3 reflects many of the items on our customers' technological wish lists. The ML-3 short is 40" to meet surveyors' personal preference, providing an ergonomic, lightweight, rugged, one-handed operation option to traditional magnetic locators. The ML-3 offers unparalleled durability, as all components are housed inside the aircraft-grade aluminum monotube units.
​
But don't let its looks fool you. The ML-3S is IP68 certified, It's 100 percent waterproof up to 250 feet - a first for the industry - so it can be used in difficult weather and submerged under water. Plus, its auto-zero feature allows the user to "cancel" ambient magnetics or magnetic gradient in the soil or water. And it's digitally tuned, so it offers unparalleled accuracy in detecting ferromagnetic objects.
​
Key Features
-
Detection of buried ferrous metal objects at depths up to 8 feet or more
-
Handgun: One to two feet 175mm
-
projectile: Four to five feet
-
Water standoff valve: Six to ten feet
-
-
Varying pitch audio signal mode using a moving coil speaker for enhanced audio output
-
IP68 Certified, waterproof and complete protection against sand, dust, and dirt
-
Waterproof sensor tube pressure tested to water depths of up to 250 feet
-
Easy-to-use, one-handed operation with four-button keypad:
-
On/Off button: Turns unit on or off
-
Zero button: Automatically calibrates unit to ambient magnetic conditions
-
Gain Up button: Increases the locating sensitivity of the unit
-
Gain Down button: Decreases the locating sensitivity of the unit
-
-
Rugged construction for field conditions
-
Low battery indication with flashing LCD
-
Includes soft case with carrying straps and inside pocket for batteries and manual; Optional aluminum hard case available
-
Underwater search and detection of Submerged vehicles UXOs and mines Salvageable wrecks Pipes and cables
-
Made in the USA - Built and serviced entirely in Wisconsin
ML-3 Long (55") - Long magnetic locator offers durable one-handed operation that's 100% waterproof
The ML-3 is a much-anticipated and welcome addition to the ML family of magnetic locators from SSI. ML-3 magnetic locators represent the best in innovation at work for the water/sewer industry, surveying industry and military.
​
That's because the ML-3 reflects many of the items on our customers' technological wish lists. The ML-3 long is 55", making it the longest magnetic locator on the market. It allows you to make the biggest sweeps possible without compromising on accuracy. The ML-3 long provides ergonomic, lightweight, durable, one-handed operation option to traditional magnetic locators. It offers unparalleled durability, as all components are housed inside the aircraft-grade aluminum monotube units.
​
But don't let its looks fool you. It's 100 percent waterproof up to 220 feet - a first for the industry - so it can be used in difficult weather and submerged under water. Plus, its auto-zero feature allows the user to "cancel" ambient magnetics or magnetic gradient in the soil or water. And it's digitally tuned, so it offers unparalleled accuracy in detecting ferromagnetic objects.
​
Key Features
-
Low battery indication with flashing LCD
-
Varying pitch audio signal mode using a moving coil speaker for enhanced audio output
-
Waterproof sensor tube pressure tested to water depths of up to 250 feet
-
Easy-to-use, one-handed operation with four-button keypad: On/Off button: Turns unit on or off Zero button: Automatically calibrates unit to ambient magnetic conditions Gain Up button: Increases the locating sensitivity of the unit Gain Down button: Decreases the locating sensitivity of the unit
-
Includes soft case with carrying straps and inside pocket for batteries and manual; Optional aluminum hard case available
-
Rugged construction for field conditions
-
Detection of buried ferrous metal objects at depths up to 8 feet Hand gun: One to two feet 175mm projectile: Four to five feet Water standoff valve: Six to ten feet
-
Detection of ferrous metal objects and weapons on persons
-
Underwater search and detection of: Submerged vehicles UXOs and mines Salvageable wrecks Pipes and cables
-
Over 3500 ML-3 units in Afghanistan used for detection of improvised explosive devises (IEDs) and Un-exploded Ordinances (UXOs)
-
Made in the USA - Built and serviced entirely in Wisconsin
Pipe & Cable Locators
Standard Items:
-
Transmitter with LCD Display and Switches
-
Receiver with LCD Display and Controls
-
Direct Connection Cables and Clamps
-
Ground Stake (use with )
-
Operating Instructions & Quick Ref. Guide (not shown)
-
Padded Carrying Case
​
The PL-2000 Transmitter offers 3.0 watts power output in the Direct Connection operating mode, allowing locates for much longer distances than the lower powers typical in other transmitters.
​
​
Transmitter and Receivers
The PL-1500 LOW
Transmitter has 3.0 watts power output in the Direct Connection Mode, allowing locates for longer distances. Use the Inductive Mode to quickly locate shorter pipes and cables.
The PL-1500 Receivers are very light-weight, weighing only 3.5lb, with large, easyto-read LCDs and thumb-controlled switches.